NextDent B.V. 3D Printer Parts NextDent Brush Scouring - Crimp Brass
NextDent B.V. 3D Printer Parts NextDent Brush Scouring - Crimp Brass
NextDent B.V. 3D Printer Parts NextDent Brush Scouring - Crimp Brass
NextDent B.V. 3D Printer Parts NextDent Brush Scouring - Crimp Brass

NextDent Brush Scouring - Crimp Brass

NextDent B.V.
500
Description

For cleaning print platforms that run elastomeric resins such as Ortho IBT or Gingiva Mask

Special Considerations for Elastomeric Resins

For cleaning print platforms that run elastomeric resins such as Ortho IBT or Gingiva Mask, your printer package includes a Wire Brush accessory. The following instructions demonstrate how to use this brush.

  1. Use the Platform Scraper to remove as much partially cured resin as you can.
  1. Identify all areas of the platform with partially cured resin and use the Wire Brush to scrape off as much as possible.
  1. Turn the print platform over and use the Wire Brush to scrape all areas that have partially cured resin.
  1. Place the print platform in solvent and use the Part-Cleaning Brush to clear away areas of liquid resin.
  1. Use the Punch Tool if desired to punch bigger chunks of material through the platform. Use the Wire Brush to scrape the remaining partially cured resin from the platform
  1. Wipe down the platform with a lint-free paper towel or nonabrasive cloth.
  1. Inspect the platform, particularly the holes on the flat surface, to ensure no partially cured resin remains. If you find resin or partially cured bits on the platform at this point, follow the steps in this section again on the problem areas.
SKU: 48-0543
NextDent Brush Scouring - Crimp Brass
500